You are advised to drink additional water before a
galvanic treatment to allow for proper conductivity of current – drink at least
one 8 ounce / 250 mL glass of water 30 minutes prior to a treatment. Since
lymph drainage is activated with microcurrent, you may feel nauseous if you do
not drink a sufficient amount of water after the treatment - once again, at
least one 8 ounce / 250 mL glass of water following your treatment.
Microcurrent will continue to stimulate adenosine
triphosphate (ATP) levels for 72-94 hours after treatment with System SG3 Galvanic
Gels. For this reason, we suggested that you perform a home-based or
professional in-clinic galvanic treatment no more than once a week. Additional
treatments will not hurt you, but are unnecessary with the use of our
At-home consumer galvanic microcurrent devices may
encourage iontophoresis, or deep penetration of water-based skin care products,
increasing the absorption rate of their beneficial ingredients. It is important
NOT to use oil-based products prior to galvanic treatments because these
products inhibit current flow.
It is important to read all warnings and directions
in the instruction-for-use or user manual of your galvanic micro-current,
ultrasound, or photofacial devices before you proceed with any treatments.
Consumer and professional galvanic micro-current,
near infra-red LED photofacial, or high frequency ultrasound (3-5 MHz) devices
were designed for cosmetic use only and for individuals in good health. If this
is not the case for you, please consult your doctor before use.
The SG – Serum Gels - skincare products are
concentrated professional grade formulations. Use just a little bit - 3 to 5
pumps of the precision dispenser - will release the correct amount of serum for
Galvanic Spa™, NuSkin Galvanic Spa II™, ageLOC Galvanic Spa™, NuSkin reDESIGN Face
Spa™ users (2 gel devices)
NOTE: Nu Skin recommends that their Galvanic Spa should not be use by people
prone to rosacea, have allergies to metal or have sensitive skin.
Wash your face and neck thoroughly and pat dry.
Leave skin damp.
1/Spa Session A/Pre-Treatment Gel to your face, and do a negative ion
galvanic treatment for 2-5 minutes. Depending on the actual hydration level of
your skin, and the fact that the serum gels actually absorb quickly into your
skin, you will probably discover that a 2-3 minute cycle is all you need.
Apply some water if skin begins to feel dry or an
additional 2-3 drops of gel.
There is no need to remove any unabsorbed gel
following the negative ion treatment phase.
2/Spa Session B/Treatment Gel your face and neck, and do a positive ion
galvanic treatment for 2-5 minutes.
Facial Spa (Single Gel Device, November 2014 - )
Nu Skin Facial Spa features a 10-minute, full-face,
basic regimen and three five-minute area regimens.
The basic regimen has a five-minute Spa Session A
and a five-minute Spa Session B. All of the area regimens include a two-minute
Spa Session A and a three-minute Spa Session B.
Apply Stage 1/Spa Session A/Pre-Treatment Gel to
your face, and do a Spa Session A treatment cycle.
Apply Stage 2/Spa Session B/Treatment Gel to your
face, and do a Spa Session B treatment cycle.
If you find that the gel absorbs into your skin to
rapidly try using the three-minute area regimen rather than the full basic
Apply the Pre-Treatment Serum Gel to your targeted
Wait one or two minutes, then apply the Treatment
Serum Gel to your targeted treatment area(s).
This is known as ‘layering’. The combined effect of the two gels will
significantly enhance your NuFACE treatment regimen.
Glide the NuFACE Classic or Trinity device over the
natural contours of your face.
Use Pre-Treatment Serum Gel with the
Bio-Therapeutics BT-Micro set on the last button (Ion -) to deeply cleanse the
skin (referred to as the ‘Clarification’ phase by Bio-Therapeutics). Treatment
time should be between 3-5 minutes for the entire face.
Next, use the Treatment Serum Gel with the BT-Micro
Ion +1 button pressed twice. Treatment time should be between 3-5 minutes for
the entire face.
You only need to do a BT-Micro negative and
positive galvanic ion treatment once a week.
Be sure to do this face massage with clean hands
and face, and leave your face damp before you begin to apply the galvanic
Use the tips of the index, middle, and ring fingers
together to exert a deep, local pressure in a tiny circular movement. You
should be able to feel the skin rubbing against the small muscles of the face.
Lift the fingers and reposition them to travel across the skin.
Use the flat pads of the index, middle, and ring
fingers together or simply the thumb to travel across the skin – either in a
slow, spiraling action, or by simply sliding upward, downward, or outward. For
the most part, keep the remainder of your hand resting lightly on your face.
Acupressure Face Massage Steps:
Apply a thin layer of Pre-Treatment Serum Gel to
the entire face area.
Place your fingertips on your jawbone and with
light pressure, make a large, sweeping circle from the jaw line up either side
of your nose to the center of the forehead, out along the hairline, and down
the temples to meet at the jawbone. This gently stimulates blood circulation
and spreads the gel.
Using the tips of your index, middle, and ring
fingers, start at the chin and travel along the jaw line and then up from the
angles of the jaw to the temples.
Next, move your index, middle, and ring fingers
each side of the nose, close to the base of the nostrils, moving first under
the cheekbones and then up toward the tops of the ears.
Place the tips of the middle fingers at the inner
corners of the eyes, slide your fingers upward, pushing against the orbital
bone, and then outward, just above the eyebrows, towards the ears.
Massage the forehead, starting just above the top
of the nose, moving up toward the hairline, and then outward until you reach
the temples. Position the pads of all three fingers at the base of the central
frown line, just above the top of the nose, and slide them toward the temples.
Bring this sequence to an end by repeating the
sweeping movement described in step 2. This sequence should last 2-4 minutes.
Now, layer the Treatment Serum Gel on the entire
Repeat steps 2 to 7.
Layering our pre-treatment and treatment serum gels
can have some major benefits for your complexion. By combining a multitude of
essential ingredients, you’ll improve efficacy, yielding more impressive
results and a healthier glow.
Rankine’s Remedies Serum Gels have been designed to
compliment each other with powerful skin-retexturizing and regenerating
Simply apply the pre-treatment serum gel until it
is absorbed and then follow with an application of our treatment serum gel. No devices or massage techniques required.